Power generation industry nozzle selection table

The table below summarises much of the information in the power generation industry section of the SNP website.  It is intended to be a handy reference guide to aid nozzle selection.  Full data on each of the nozzles listed can be accessed by clicking on the boxes in the left hand column of the table below. The data sheets will open in a separate tab to allow easy comparisons between multiple product sheets.

 

Nozzle Type

 

 

 

 

Design Type

 

 

 

 

Minimum flow rate

 

 

 

 

Profile

 

 

 

 

Injection uses

 

 

 

 

PJ series Low profile misting nozzle

 

 

 

 

Impingement

 

 

 

 

0.034

 

 

 

 

Medium

 

 

 

 

Gas only for low flow rate

 

 

 

 

Microwhirl misting nozzle

 

 

 

 

Small orifice misting nozzle

 

 

 

 

0.032

 

 

 

 

Lowest

 

 

 

 

Gas or liquid low flow rate.

 

 

 

 

Low flow rate spiral nozzle

 

 

 

 

Spiral

 

 

 

 

0.534

 

 

 

 

Long

 

 

 

 

Gas only

 

 

 

Medium to high flow rates

 

 

 

Clog-resistant

 

 

 

 

 

 

 

 

Tangential whirl full cone

 

 

 

 

0.8

 

 

 

 

Low

 

 

 

 

Gas or liquid

 

 

 

Medium to high flow rates

 

 

 

Clog-resistant

 

 

 

 

PJ series Low profile misting nozzle

 

 

 

 

Impingement

 

 

 

 

0.034

 

 

 

 

Medium

 

 

 

 

Gas only for low flow rate

 

 

 

 

Microwhirl misting nozzle

 

 

 

 

Small orifice misting nozzle

 

 

 

 

0.032

 

 

 

 

Lowest

 

 

 

 

Gas or liquid low flow rate.

 

 

 

nozzle catalogue

Power Generation Key Spraying Applications

Power Generation Key Spray Challenges

Share
 

Share |

BETE Blogs